If a wireless connection does still not exist, make sure that the wireless radio has not been disabled. Reboot process takes approximately 30 seconds. PDA – Use the PDA stylus to push the reset button located on the back side of the PDA. In most cases, the easiest way to re-establish a connection is to perform a cold boot of the ScreenLogic device:Ī. Make sure your wireless ScreenLogic device (PDA and/or Tablet) are connected to the ScreenLogic If ScreenLogic has been previously working without a problem, try the following steps to resolve the problem:ġ. If the Configuration program displays “Looking for controller,” for longer then 60 seconds when you start IntelliTouch ScreenLogic, this may indicate a communication problem somewhere in the system. Why does the Configuration program say “Looking for Controller”? Note: If you purchased a PDA, In-wall touch screen, or Tablet, a CD-ROM is also included that contains the ScreenLogic PC interface for your Windows XP computer. For Technical Support contact information, see page viii. Please consult your manufacturer documentation for other questions.

Technical support for non-supported devices is not available. IntelliTouch ScreenLogic can only be used with the provided ScreenLogic PDA, Tablet, and in-wall Touch Screen devices. Use the following information to resolve general ScreenLogic operation issues.īefore contacting Pentair Water Technical Support, please note that Technical Support personnel can only assist with relevant questions regarding IntelliTouch ScreenLogic hardware and software.

Screenlogic2 interface protocol adapter